Shower Repairs in Poway, CA. | Big B's Plumbing
Big B's Plumbing is your trusted shower repair service expert in Poway, CA. Serving Poway for over a decade, we have thousands of top-notch reviews for service calls completed. We perform quality repairs for all our customers. When you hire our team for shower repairs, we will do our best to repair anything from leaks and clogs to low water pressure and faulty valves. We're experts in all things plumbing, and you're free to tell us exactly what you need, and we'll give you a written estimate before work starts. Call Big B's Plumbing if you have any problems with your shower, from a leaky faucet to a clogged showerhead. We're the top shower repair service in Poway and want to help you keep your shower running perfectly.
Big B's Plumbing - Your Plumber for Life!
No Hot Water Could Spell Trouble for Any Household
A lady called in and said, "I went to the shower and switched it on, but the water was cold." I was trying to figure out what the problem was. We replied, "There are a few possibilities for the cause of the problem. This could be due to a faulty water heater, which could be either the thermostat or the heating element." It could also be due to a faulty mixing valve in the shower, also called a thermostatic valve, which mixes the hot and cold water.
The problem could also be caused by sediment in the water heater or a restricted pipe, which does not allow the hot water to pass through. It is well worth looking at all of these components to ensure effective shower repairs are done to restore the hot water flow.
Bad Diverter Valve: Replace or Repair it ASAP
A shower diverter valve is a part of a shower arrangement used to divert the water flow between a bathtub spout and a shower head. By pulling up on a diverter knob or lever, you prevent the water from flowing through the bathtub spout and make it flow through the shower head so that you can take a shower. On the other hand, pushing it back down allows water to flow through the bathtub's spout so that you can take a bath.
When the diverter valve breaks, you may have less water pressure coming out of the showerhead, water may continue to flow out of the bathtub spout even when the diverter is thrown into the tub position, or the valve becomes stuck so that you can't switch between the tub and the shower. A bad diverter valve can waste water and provide an inadequate shower, and you'd want to have it replaced or repaired as soon as possible to restore the flow.
There are Many easy Solutions for a Leaky Showerhead
There could be many reasons why the shower head leaks. One reason could be that the washer or O-ring inside the shower head is worn out or damaged, and water seeps through even when you turn off the shower. Another reason could be that the connection between the shower head and the shower arm is not tight, or the threads might be damaged or corroded. Additionally, it could be as simple as wrapping your shower arm threads with plumber's tape.
First, turn off the water supply to the shower. Then, remove the shower head and check the washer or O-ring, replacing it if it is worn or damaged. Clean the threads and put some plumber's tape on the shower arm. Finally, reattach the shower head to create a tight seal. The shower head might need replacing if this does not solve the problem. These basic shower repairs can stop the leak and restore your shower to full working condition. Remember, most shower heads are easy to replace and won't break the bank.
Family Owned & Operated
My name is Brandon Mageno. I'm the founder, President, and CEO of Big B's Plumbing Company. As the founder, I never thought about being average or good. My passion for being the best plumbing company in Southern California has always been the same. Providing plumbing services to this great county is simply in my DNA. Nothing makes me happier than to see a satisfied customer. Learn More About Us
Shower Repairs: An Experienced Plumber Should Repair or Replace The Thermostatic Valve
If you suspect the thermostatic valve in your shower is bad, here's how to tell: The water temperature might be inconsistent—you turn the controls, and the water suddenly becomes either too hot or too cold and never adjusts. Or it might not get hot enough, but it takes a long time to adjust. The valve might be stuck—you cannot change it. To repair a shower with a faulty thermostatic valve, you would start by turning off the water supply to the shower. Then, remove the shower cover and handle so you can access the valve itself. Look for any obvious signs of damage or wear, such as corrosion, mineral deposits, or discoloration.
If the valve is visually damaged, it is probably time to replace it with a new one, but if it is just dirty, you can clean it with vinegar to remove deposits. Although experienced DIY homeowners may feel confident enough to repair the problem themselves, it is often best to call a plumber. While there are some shower repairs that the average homeowner can handle, a thermostatic valve is not one of them. A plumber has the experience and equipment to diagnose the problem and repair it properly, hopefully quickly, preventing further issues and costly water damage.
Low Water Pressure May Require Shower Repairs
Are you exposed to low water pressure in your shower? There are a few factors that might be causing this issue. A common one is the clogged showerhead, where mineral deposits or debris get caught on the nozzles, restricting the water flow. Another issue could be a partially closed or blocked valve in your plumbing system that might reduce the shower's water supply. Leaky plumbing, visible or hidden behind the walls, reduces the water pressure. Faulty pressure regulators or problems with the municipal water supply might also be causing this issue.
Your Opinion Matters!
How to Clean Your Shower Head
If water pressure is low in your shower, start by removing the showerhead, soak it in vinegar to dissolve any mineral build-up, and check the water flow from the shower arm. After checking the flow of water from the shower arm and water pressure is fine reinstall the showerhead. If the hard water deposits were removed your shower should be at full-flow. However, if your water pressure is low coming out of the shower arm, then the problem is coming from a different area of your plumbing system. Call Big B's Plumbing if you've covered these steps and still have low water pressure. The problem could be deeper than the showerhead and may involve your home's pressure regulator or some other deep-seated plumbing issue.
You Can Expect Quality Workmanship at Big B's Plumbing
There are several benefits to hiring the services of Big B's Plumbing for shower repairs in Poway, CA. Whether you have low water pressure from a leaky pipe or a broken thermostatic valve in your shower, one of our experienced plumbers will make your showers work like new again. You can expect quality workmanship at Big B's Plumbing; your repairs are guaranteed. Our response times are some of the industry's best with a state-of-the-art call center. Whether it's your bathroom or spa shower, with Big B's Plumbing, you can expect shower repairs you just can't beat.
What People Are Saying...
I called Big B's Plumbing because I the hot water would not turn off in our master bathroom. I tried to turn the valve off under the sink and it broke off, so I had to shut off the main water to the house. It was noticeable the valves were original to the home. When I called, the rep stated that I would be informed about the service tech and their experience along with services offered "On The Spot". I was on a bit of a time crunch...
Read More on Google My Business
Vill M
Found them on Google and they had good quality reviews. Made the call and set up the appointment for same day. Dispatch called me a few hours later to confirm our appointment and let me know that the technician Mathew was on the way. This was supposed to be an easy job once Mathew arrived. But it turned out to be so much more than that. Without hesitation or a sour look on his face, he dove deep into his van...
Read More on Google My Business
Jeremy T
Randy was very knowledgeable and professional. He helped us figure out what we could do with the space given for our bathroom with our remodel. He picked out perfect fixtures and the work he did was beautiful. The cleaned up properly when they were done and everything was handled in one day! I will be calling for Randy anytime we have any plumbing needs. Thank you for doing such a great job!
Read More on Google My Business
